cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Announcements
Choose one of the topics below to view our ISE Resources to help you on your journey with ISE

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

499
Views
5
Helpful
2
Replies
Highlighted
Beginner

ACS 4.2 Preferred EAP Protocol

ACS 5.x can configure preferred EAP protocol:

Preferred EAP protocol

Select the preferred EAP protocol from the following options available:

EAP-FAST

PEAP

LEAP

EAP-TLS

EAP-MD5

This option helps ACS to be flexible to work with old supplicants (end devices) which are not capable of sending No-Acknowledgement, when a particular protocol is not implemented. You can use this option to place a particular protocol first in list of protocols that is being negotiated with device so that the negotiation is successful.

Any way to configure that in ACS 4.2?

Thanks.

2 REPLIES 2
Highlighted
Participant

ACS 4.2 Preferred EAP Protocol

As such, there is no option like this in ACS 4.x.

Which protocol are you concerned with?

ACS 4 works with most older supplicants especially ones that LEAP as well.

In ACS 4 if LEAP is enabled, its the first protocol that is proposed.

ACS 5 will always propose EAP-TLS even if LEAP is enabled unless configured to change that.

**Share your knowledge. It’s a way to achieve immortality.
--Dalai Lama**

Please Rate if helpful.
Regards
Ed

**Share your knowledge. It’s a way to achieve immortality. --Dalai Lama** Please Rate if helpful. Regards Ed
Highlighted
Beginner

ACS 4.2 Preferred EAP Protocol

We want to make EAP-MD5 the first to use. Supplicants are some switches for MAC based Authentication.

Any way can make it for ACS 4.2 such as some internal cli configure, window registery table editing or tweak?

Thanks.