Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We run into a problem when AP 3700 is connected to an 802.3at PSEthat only supports physical event classification as compliant to 802.3at standard for PSE,but does not support CDP/LLDP power negotiation.AP 3700 (I believe the firmware version does n...
A recent case prompted me to share the information with community.DHCP server pool is 192.168.100.200~192.168.100.250, subnet mask 26, DHCP relay agent IP 192.168.100.1/24, not included in DHCP server pool subnetDHCP relay agent will translate broadc...
ACS 5.x can configure preferred EAP protocol:Preferred EAP protocolSelect the preferred EAP protocol from the following options available:•EAP-FAST•PEAP•LEAP•EAP-TLS•EAP-MD5This option helps ACS to be flexible to work with old supplicants (end device...
Sx300/500 series switches can team together with Cisco ISE (Identity Service Engine) and Windows AD server to provide integrated 802.1x AAA (authentication/ authorization/ accouting) using Windows domain username/password for end user device.This doc...
Introduction:Topology Diagram:Configuration Overview:Related Information: Introduction: This document describes how to connect SG300 with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that runs on mainly on switches. The...
Hi Tim,Sure that will be part of the investigation. Current information on the case is clear and this will raise awareness internally. If any further help needed, will contact you, thanks.
The occasional loss of configuration in 1.3.5 may due to the system is under some sort of exception condition, such as dealing with other tasks, that prevents voice vlan command to be executed.Auto smart port feature is an automation mechanism and wh...
Hi Tim,Thanks for the information and given this situation, it looks like 1.3.5 is a better option for production network.The issue found in 1.4.0 will be raised internally.
Hi Tim,I saw this problem in 1.4 while not in 1.3.5.Now there is a solution for this issue, which is to add the trunk native vlan setting to the user defined macro so that it will finally be recovered after reboot. no macro auto user smartport macro ...
Please make sure the load balance mode in VMware is Route based on IP Hash.The default value is virtual switch port ID, which cannot work together with port-channel in upstream switch, as explained in: http://www.vmware.com/files/pdf/virtual_networki...
