ACS 5.2 802.1x EAP-FAST w/MSCHAPv2, Cisco WiSM WLC, AD 2008

[rob.schieron]

Hi All,

I'm currently trying to replace an old ACS v3.3 with v5.2.0.26.2.

Looking to authenticate wireless clients with EAP-FAST, MSCHAPv2 inner method against AD.

Coming up against a lot of issues to do with the authentication - no problems on the AD side, but getting the EAP-FAST config right on the ACS is proving difficult.

I found this guide for PEAP-FAST(MSCHAPv2), does anyone know of anything similar for EAP-FAST(MSCHAPv2)?

http://www.cisco.com/image/gif/paws/112175/acs51-peap-deployment-00.pdf

Any guides for ACS 5.x with EAP-FAST would be very helpful, especially to do with certificates, pac provisioning, etc.

Thanks,

Rob

[dlignier]

Hello,

Did you find a guide for EAP-FAST with AD ?

I'm facing the same problem, I can't make EAP-FAST working with AD Account,

Thanks to you

Regards,

Gérald