Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have raised a TAC for this but thought I'd post here too.We are running ACS v5.4 Patch 1.We have noticed that ACS will not produce syslog messages about scheduled backups (success or failure)(1) From the GUI, under “System Administration > Config...
Hi All,I'm currently trying to replace an old ACS v3.3 with v5.2.0.26.2.Looking to authenticate wireless clients with EAP-FAST, MSCHAPv2 inner method against AD.Coming up against a lot of issues to do with the authentication - no problems on the AD s...
Fresh build, patched to 5.2.0.26.2 no problem.Then, patch the box to 5.2.0.26.3:exc2-acs-1402/admin# acs patch install 5-2-0-26-3.tar.gpg repository networktools-patchInstalling ACS patch requires a restart of ACS services. Continue? (yes/no) yesSto...
All,Very basic failure here I've replicated on both VMWare and 1120 hardware appliance.1. Run a full install (fresh reimage), allow the system to start fully. Ensure DNS is ok and the server can ping the gateway etc.2. Patch straight to 5.2.0.26.3 v...
reposting as with subject including v5.2:--------HelloI have an ACS 4.2.1.15 patch 3 and Novell Netware LDAP Server separated by a Firewall. The Firewall's default tcp session timeout is 3600 seconds.When no LDAP-Request is made for over one hour, th...
Hi Stephen,Patch bundles, suggest you download patch bundle 2. Also, sorry, I did mean 5.2.0.26.2 (not 5.2.0.44.2).You need to d/l 5-2-0-26-2.tar.gpg and patch appropriately.Did a computer account for the ACS turn up in AD when you joined the domain...
First thing to check is your ACS hostnames. Are they longer than 15 characters? This is what caused all the trouble for us, after a rebuild to shorter 15 chars-or-less ACS hostnames, everything worked fine.Of course, make sure that DNS is set up co...
There is a way around this. Have a look at "device filters", you can set these up to filter by IP.This way, you can add single IP address rules into your rule tables, that are specific for possibly "different" devices in the middle of large address ...
Yes, wrong number also shown in the GUI.I'm not going to raise a TAC case about this, if I raised a TAC case for every ACS fault I wouldn't ever get anything done!!
Sounds to me like a backup process has hung. Can you upload the contents of a show tech-support?Basic advice - have you rebooted the box? I have seen this kind of thing before, a reboot usually clears it.Also - when the instance comes up again, do ...
