Solved: Re: ACS 5.2 - Support for Per-User RADIUS Attributes

lmslattery · ‎08-08-2011

Hi All,

Does anybody know whether it is possible to configure RADIUS attributes on a per-user basis within ACS 5.2 ?

This was possible under ACS 4.x howver I don't seem to be able to find reference whether ACS5.2 supports it.

Thanks,

Leon

jrabinow · ‎08-09-2011

You can do this by defining per use attributes and then doing attribute substution.

You can see an example of this where define an internal user attribute to be used as the value for the Framed-IP-Address field

This is just an example and can be applied equally to any RADIUS attribute where define a user attribute of the same type. The values may equally be taken from an external identity store like AD

View solution in original post

jrabinow · ‎08-09-2011

You can do this by defining per use attributes and then doing attribute substution.

You can see an example of this where define an internal user attribute to be used as the value for the Framed-IP-Address field

This is just an example and can be applied equally to any RADIUS attribute where define a user attribute of the same type. The values may equally be taken from an external identity store like AD

lmslattery · ‎08-09-2011

Thanks for your reply !

This was exactly what I was looking for.