09-13-2012 02:28 AM - edited 03-10-2019 07:32 PM
Dear All,
This is the great place for ACS discussions , i need two more inputs from experts
acsserver | Thu Sep 13 14:35:28 UTC 2012 | pughaz | 15 | [ CmdAV=ip tacacs source-interface FastEthernet 0/1 ] | Device Type:All Device Types:ROUTERS, Location:All Locations:NON DC DEVICES |
On the above message
1. Need to chang time from UTC to IST
2. The Device column is not showing the exact device name ; i telnet and config changed , it is showing the device group name only , how to get the exact device name i telnet on this message
Solved! Go to Solution.
09-13-2012 07:39 AM
Hi,
You can change the timezone through the cli:
To get the exact syntax of the timezone-
Here is the command to do this -
As far as the device name not showing up, can you check the column settings and see if that may been removed.
Thanks,
Tarik Admani
*Please rate helpful posts*
09-13-2012 07:39 AM
Hi,
You can change the timezone through the cli:
To get the exact syntax of the timezone-
Here is the command to do this -
As far as the device name not showing up, can you check the column settings and see if that may been removed.
Thanks,
Tarik Admani
*Please rate helpful posts*
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide