ACS 5.x Tacacs Accounting report

[jlhainy]

I am setting up reports for tacacs accounting on ACS 5.3.  However, accounting only seems to work after entering enable mode on the switch.  I would like to see all commands, even the enable command when in privlage 1 mode.

[jlhainy]

never mind.  I guess it just doesn't show the enable command itself.  All other commands seem to be being logged. 

[minkumar]

Hi JiHainy,

  Did you enable accounting on the switch or router?

If its an IOS, make sure that you have command accounting enable for all the three levels:

aaa accounting commands 0  default start-stop tacacs+
aaa accounting commands 1  default start-stop tacacs+
aaa accounting commands 15 default  start-stop tacacs

Let me know if it gives out desired output.

Regards
Minakshi (Do rate the helpful posts  )