04-15-2009 12:39 PM - edited 03-10-2019 04:26 PM
Hi, I have an ACS 1112 appliance that is currently running on 4.1 and was brought up to patch level 4.1.1.23.3. We were attempting to install patch 4.1.1.23.4 through the Web Console when we lost connectivity and never got it back. After logging in through the serial console, it indicated that an 'upgrade was in progress'. I was able to successfully re-run the install for 4.1.1.23.4 through the serial interface, along with 4.1.1.23.5, however, even after several reboots, I still cannot gain access to the Web Console. I also confirmed that CSAdmin is up and running. Is there anything I can do to remedy this issue without rebuilding the entire device? Thank you.
04-15-2009 01:23 PM
If you still see upgrade in progress message simply issue following command from console
download 1.1.1.1
You can use any IP address.
Regards,
~JG
Do rate helpful posts
04-16-2009 04:46 AM
I was able to install the patches through the serial console without an issue. The issue that I am trying to resolve is accessing the Web interface to the console. When I enter the 'ip address:2002' to get to the console from IE, I get 'page cannot be displayed'. CSAdmin is up and running. Any advice on how I can fix the access to the web console? Thank you.
04-16-2009 05:11 AM
Make sure that you have the Remote Agent matching you ACS Version 4.1.1.23.5.
I've seen issues where ACS was trying to contact RA and GUI became unresponsive.
Also, by default the ACS allows any TCP ports to be used for Administration HTTP Access, but this could be limited once you gain access.
My point here is that if the web access was working before, it might not be the case, but you could be blocked by a firewall/pix/asa...
Try from a different PC, and a different browser...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide