Hi there
i try to configure a juniper ex4200-48t's radius service on ACS5.2 to authorize ACS internal user to admin it
i have read and search related article
such as
http://forums.juniper.net/t5/ScreenOS-Firewalls-NOT-SRX/Juniper-SSG-and-Cisco-ACS-v5-x/m-p/127033
which is a tutorial of radius for Juniper Netscreen device
i following those step for my Juniper SW and failed too.
is there any difference attribute and value between Juniper Netscreen and Switch ?
what should i setup into custom attribute of shell profile of Device administrotor of ACS5.2
thanks so much