ACS Se 4.2.1.15 patch 4 and Windows 2008 R2

[apanesar]

Hi, Can anyone advise whether ACS Se and Remote Agent 4.2.1.15.4 supports Windows 2008 R2 please. Thank you.

[andamani]

Hi,

ACS 4.2.1.15 does not support windows 2008 R2.

ACS 5.2 supports the same.

It is a bug CSCtg12399 which is resolved on ACS 5.2.

The release notes of ACS 5.2 describing the same.

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.2/release/notes/acs_52_rn.html

The following link gives details of the ACS 4.2 and Windows 2008 compatibility.

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.2/release/notes/ACS42_RN.html#wp100949

Hope this helps.

Regards,

Anisha

P.S.: please mark this thread as answered if you feel your query is answered. Do rate helpful posts.

[apanesar]

Hi Anisha, Thank you for the quick response.

Do you happen to know what the upgrade patch would be to get from ACS Se 4.2.0.124.17 to 5.2 (and same for Remote Agent). Also what are the implications for licensing??

Thanks

Amerjit

[andamani]

Hi,

You will have to purchase a ACS 5.2 solution engine. it is supported on Appliance 1120 and 1121 as of now.

ACS 4.2 is a windows based application while ACS 5.2 is not windows based but linux based.

Also license is required for the ACS 5.2.

Hope this helps

Regards,

Anisha

P.S.: please mark this thread as answered if you feel your query is answered. Do rate helpful posts.

[andamani]

Hi Amerjit,

The link below clearly states that Windows 2008 R2 is not supported by ACS 4.2.1.

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.2.1/Installation_Guide/windows/install.html#wp1041324

Hope this helps.

Regards,

Anisha

- Do rate helpful posts.

[apanesar]

Thanks

[andamani · Accepted solution]

Please mark this thread as answered so that others can benifit from the same.

Regards,

Anisha

- do rate helpful posts.