Adding VSA on the ACS Appliance

[engel]

Dear All,

How to add the other Vendor Specific Attributes on the ACS Appliance ? Normally on the software , we use the command line "CSutil" to add the VSA, but since the appliance doesn`t have interface to the windows system, there is no way to configure it. Does anyone know how to do it?

Appreciate for any insight

[gfullage · Accepted solution]

Beginning with 3.1, ACS supported custom VSAs with RDBMS Synchronization, too. This was done specifically to support the appliance. Action codes 350 through 355 support custom VSA definition and config.

So, consult the ACS 3.2 appliance user guide for info about using RDBMS Synch.

Some links:

Topic about RDBMS support for VSA import:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacsapp/user/sad.htm#451579

Beginning of RDBMS feature doc:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacsapp/user/sad.htm#451426

Synch. codes appendix:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacsapp/user/ag.htm

Table with relevant action codes:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacsapp/user/ag.htm#1372