Any issue / bug affecting cisco ise 3.1 patch 7?

[devendran.raju]

Hi All,

We are planning to update Cisco ISE 3.1 patch 7 version from 3.1 p3

We would like to know if anybody faced issue or bug affecting patch 7 after updating from previous patch versions?

FYI. We are using Cisco ISE dot1x (peap & eap-tls), profile and posture service in our customer environment and using Aruba switch & WLC as NAC. 

[Mark Elsen · Accepted solution]

 - FYI : https://bst.cisco.com/bugsearch/bug/CSCwh17435
           https://bst.cisco.com/bugsearch/bug/CSCwf80386   (not applicable for your scenario)
           https://bst.cisco.com/bugsearch/bug/CSCwh52589
           https://bst.cloudapps.cisco.com/bugsearch/bug/CSCwf80292

 M.

[Arne Bier]

Hi @devendran.raju 

I have one customer whose ISE 3.1 was fresh built, and patched to patch 3 initially. Last week we went to patch 7. No issues at all.

Customer uses this for wired MAB/802.1X (EAP-TLS), Profiling and TACACS+ only.

They have a mix of VMs and SNS-3615 appliances. We did manual patching via the CLI.