cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
440
Views
0
Helpful
1
Replies

AnyConnect and NAC Agent

dgaikwad
Level 5
Level 5

Hi Experts,

As we are migrating from NAC agent towards AnyConnect, we already have 80% endpoints with AnyConnect pushed via SCCM. The question is for the remaining 20% that would be affected...
Is there anyway to process posture and compliance using AnyConnect or NAC agent?
That is, when AnyConnect is installed posture will happen using AnyConnect and if AnyConnect is not installed then using NAC Agent?
Also, the conditions from Client Provisioning does not provide a condition to check if AnyConnect is running, to allow posture via AnyConnect else via NAC agent...


Any Pointers?

1 Reply 1

Timothy Abbott
Cisco Employee
Cisco Employee
As you migrate from NAC agent to AnyConnect, you can have the NAC agent uninstalled. You specify that in the AnyConnect configuration.

Regards,
-Tim