10-11-2012 07:23 AM - edited 03-10-2019 07:39 PM
Hi,
If anyone could help with this I'd appreciate it.
I've configured an ACS 5.3 system and all my groups etc fucniton corrcetly both for Network Access and for Device Administration.
However I'm stuck trying to allow clients to authenticate against the router's web-page i.e. Web-Authenticaiton, using TACACS+ between the router and the ACS5.3.
I've looked into this and I need to configure a custom-attribute of "service" with type Outbound and link this to an Authorization policy.
I feel that configuring the Custom Attributes is where I'm stuck.
Once agin thanks for any help,
Brian
Solved! Go to Solution.
10-11-2012 10:18 AM
Your best bet is to use radius, ACS supports radius and for the most part you try to segment network access users from your device admins, and the best way to do that is using radius versus tacacs.
Thanks,
Tarik Admani
*Please rate helpful posts*
10-11-2012 10:18 AM
Your best bet is to use radius, ACS supports radius and for the most part you try to segment network access users from your device admins, and the best way to do that is using radius versus tacacs.
Thanks,
Tarik Admani
*Please rate helpful posts*
10-12-2012 01:25 AM
Yes I did consider that. Do you know of a document which lists how to enter the correct attributes e.g. service=outbound?
10-23-2012 05:07 AM
Thanks for your suggesiton. As the previous version of ACS was configured with RADIUS I'm being pressed to use that. However thanks for your assistance Tarik.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide