cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1247
Views
15
Helpful
2
Replies

AP dot1x feature is disabled

Hello Gents,

 

I am looking to have the AP 9120AX as EAP-TLS supplicant,

 

AP#show ap authentication status
AP dot1x feature is disabled.

 

There is an option to user credentials for the EAP-PEAP.

AP#capwap ap dot1x username user1 password ***

 

How can the AP be set to user a certificate (EAP-TLS) rather than credentials (PEAP) for authentication.

 

Thanks,

1 Accepted Solution

Accepted Solutions

thomas
Cisco Employee
Cisco Employee

It would help to know which software release you are using next time and if you looked in the configuration guide or not.

I found this with an internet search of "17.6.1 wireless controller configuration guide"

Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide > 802.1x Support > EAP-TLS/EAP-PEAP Protocol

View solution in original post

2 Replies 2

balaji.bandi
VIP Guru VIP Guru
VIP Guru

thomas
Cisco Employee
Cisco Employee

It would help to know which software release you are using next time and if you looked in the configuration guide or not.

I found this with an internet search of "17.6.1 wireless controller configuration guide"

Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide > 802.1x Support > EAP-TLS/EAP-PEAP Protocol

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers