Hi we have a router which acts as an LNS and authenticates LT2P sessions via radius assigning each to a tunnel interface and giving it an IP address, we would also like to assign DNS settings via radius, we are using steel belted radius which is capable of doing this but we can't seem to get it to work.
What I believe are relevant sections of the config are below;
Any help greatly appreciated.
Thanks
Matt
!
version 12.2
aaa new-model
!
!
aaa authentication login default line
aaa authentication ppp default group radius
aaa authorization network default group radius
aaa session-id common
!
!
ip name-server 4.2.2.2
!
vpdn enable
!
vpdn-group conn
accept-dialin
protocol l2tp
virtual-template 1
terminate-from hostname G20
local name wllns
l2tp tunnel password 7 050703062F4D4A064B
!
vpdn-group test_G30
accept-dialin
protocol l2tp
virtual-template 1
terminate-from hostname G30
local name wllns
l2tp tunnel password 7 06115E3349420C0A161B420C5D076724762121302E120912
!
vpdn-group test_G40
accept-dialin
protocol l2tp
virtual-template 1
terminate-from hostname G10
local name wllns
l2tp tunnel password 7 131246000E0001393828783464215E08440A135355595D50
!
!
interface Virtual-Template1
ip unnumbered FastEthernet0/0
no ip route-cache
peer default ip address pool mypool
ppp authentication chap
!
ip local pool mypool 172.20.0.1 172.20.30.254
radius-server host 172.21.0.252 auth-port 1645 acct-port 1646
radius-server key test
radius-server authorization permit missing Service-Type
call rsvp-sync
!
!
!
end