05-28-2004 08:09 AM - edited 03-10-2019 07:50 AM
May I get from the router with Auth-Proxy Accounting turned on not
only
attribute 42 (Acct-Input-Octets), but also an attrubute 43
(Acct-Output-Octets).
In the
http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/products_feature_guide09186a0080080348.html
I can read that:
The Authentication Proxy Accounting for HTTP feature provides "start"
and "stop" accounting records with enough information to be used for
billing and security auditing purposes.
Without Acct-Output-Octets attribute it's not "enough information to
be used for billing"
06-03-2004 05:59 AM
attribute 42 and attribute 43 cannot be turned on simaltaneously, as far as I know
06-03-2004 06:47 AM
For example, in the
we can see the following:
Service Stop
When a service is terminated, the Cisco 6510 sends a RADIUS accounting-request to the accounting server. The attributes associated with this record are:
Acct-Status-Type = Stop
User-Name = "service"
NAS-IP-Address = ip_address
Acct-Input-Octets = in_bytes
Acct-Output-Octets = out_bytes
Acct-Session-Time = time
Acct-Terminate-Cause = cause
Acct-Session-Id = "session_id"
Proxy-State = "n"
service
Name of the service profile.
ip_address IP address of the Cisco 6510 interface card 1.
in_bytes Number of inbound bytes.
out_bytes Number of outbound bytes.
time Length of session in seconds.
cause Cause of account termination. These include:
Lost-Carrier
Lost-Service
Host-Request
Session-Timeout
session_id Session Number
n Accounting record queuing information (has no effect on account billing).
Or another example
NAS-IP-Address = 10.1.0.18
NAS-Port = 30202
NAS-Port-Type = ISDN-Sync
User-Name = "user9"
Calling-Station-Id = "6228213"
Acct-Status-Type = Stop
Acct-Authentic = RADIUS
User-Service-Type = Framed-User
Acct-Session-Id = "0000005B"
Framed-Protocol = PPP
Acct-Link-Count = 2
Framed-IP-Address = 10.1.0.35
Acct-Multi-Session-Id = "39"
Acct-Input-Octets = 580
Acct-Output-Octets = 751
Acct-Input-Packets = 39
Acct-Output-Packets = 48
Acct-Session-Time = 298
Acct-Delay-Time = 0
Both attributes sent to RADIUS server and we can get full information for billing . But when we turn on accounting on auth-proxy, router send only one attribute. How we can make billing if we have only one attribute?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide