Network Access Control

Hello,I'am authenticating the vpngroup users through a AAA (ACS 3.2). I want to know if there is any way for the pix to send accounting info to the AAA about the vpngroup.Thanks for your help.Regards, Anacelia

we are having an issue when trying to run CMS on a device which is configured for TACACS+ . Telneting to the device works fine and authenticates you against the ACS server but when you try and run CMS it just hangs while trying to load the feature me...

I configured a 7401ASR Router for authentication proxy and it worked properly. In this morning it didn't work but the dynamic access-list from TACACS+ server was still added to the router. I haven't changed anything on TACACS+ server and router also....

Hi all, I'm trying to configure wired 802.1x security on a Catalyst 4506 IOS 12.1.19(EW), using Microsoft IAS (Microsoft's RADIUS), and Windows 2000 SP4 clients. I've followed the procedures in the 4506 Software configuration guide and they seem to b...

I have Cisco ACS SE 3.2.3, 1200AP, 3550, 4000.I have an problem with dynamic VLAN assignment.4000 is running 7.6.73550 is running 121-20.EA1a1200 is running 12.2(15)JAACS is running 3.2(3) build 11The AP is looking for the VLAN ID (number), but the s...

Can I use TACACS+ to authenticate users who access Cisco VPN 3000 Concentrator using VPN Manager for management purpose?

I would like to know if anybody have a sample or a cisco page that teachs to how to configure a PIX Firewall with version 6.3 to make a user that want to access internal resource on inside, first need to authenticate in local data base (PIX) for pre ...

I would like to install a test on the ACS device. Can anyone out there recommend which group to use? I have the Default server group already cloned, but is there anything that I would need to do different for Cisco ACS? Also, is there any good materi...

HI guys, i have Cisco ACS 3.0 running and i have confiiguration like belowaaa new-modelaaa authentication login default group tacacs+ enableaaa authorization exec default group tacacs+ if-authenticated aaa authorization commands 15 default group taca...

I have this configuration on my cisco 1700 router:--------------------version 12.3service timestamps debug datetime localtimeservice timestamps log datetime localtimeservice password-encryption!hostname remote-aoud!!clock timezone ITA 1clock summer-t...

Hi guys,I am able to set some user privildge level below 15 and when they type conf t, it tells them the command does not exist(^ input...bla bla)but what i expect is not such answer, instead when they type conf t, it should show "no authorization"ho...

Has any one used the RADIUS server that comes with Windows 2000 Server? I have a small network 15+ switches, and a router. I want to increase security a little and have user name and password, but I can't justify the money for the Cisco server. I’m j...

Dear all,I would like to access into the enable mode with two different way.The first one is by using radius authentication with a telnet connectionThe second one is by using the local enable password for a console accessWith CatOs we can easily do t...

In the past i have heared there exists many problems with the cisco secure acs software and service pack 4 from microsoft. We want update the acs to version 3.2? Is the acs 3.2 SP4 ready???Thanks Maik

Has anyone configured AAA on a FWSM V1.1.3 I am testing with no radius server available The command I am using is aaa authentication supervisor console tradius [LOCAL] However the local element does not appear in the config and no access is available...