authentication new-style config on cisco 2960 switches

[Anthony O'Reilly]

Hi,

I have two ISE 2.7 Patch 2 virtual devices.

I have a test switch with some users and phones on it. My aim is for laptops, desktop and wyse terminal to authenticate using dot1x. The Cisco phone will authentication via mab. 

The Cisco IOS is: C2960X Software (C2960X-UNIVERSALK9-M), Version 15.2(4)E6

I can get the laptops and phones to authentication but when I issue the command "authentication display new-style" the "show authentication session" no longer works. 

I have attached the config that I applied pre "authentication display new-style".

     Dot1x is working and I can see the devices on ISE with the switch as a NAD on ISE.

However, I am concerned about my config after I apply the new-style that maybe it will not work in production. See config applied post "authentication display new-style"

Am I doing something wrong.

[Rob Ingram · Accepted solution]

@Anthony O'Reilly 

When you've converted to the new-style, the command is now "show access-session" instead of "show authentication session"

HTH

[Anthony O'Reilly]

Thanks Rob