08-15-2022 03:24 PM
hello,
the problem is that in a layer 2 switch the authentication does not work with the equipment through the ISE, it does not show any log, and the authentication can only be done through the local user.
The configuration has been reviewed with another similar device and there is no variant.
08-15-2022 03:53 PM
Let me look into my crystal ball ... I see ... I see ... NOTHING. You need to provide us with some technical information. E.g. what are you doing here (MAB, 802.1X), show us your switch config, and errors - relevant ISE config
What have you tried to troubleshoot so far, apart from comparing it with another working device? What are the differences between those two devices ? There must be something.
08-15-2022 04:04 PM
See How to Ask The Community for Help
What information do you think the TAC would need to help you? We need it too!
08-15-2022 04:35 PM
Agree with Arne and Thomas, if you are sure a similar switch with exact same config is working and this one is not, probably simplest to make sure this non working device is added on ISE and that shared secret is correct and then run a aaa test from switch "test aaa ?" (fill rest of info)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide