cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

1271
Views
0
Helpful
0
Replies
kai.onken
Beginner

Auto Smart Port and "if [[ $LINKUP == NO ]];...." not working

Dear sirs,

 
I have successfully configured network access on the ISE 2.3. On a successful authentication, a trigger is sent to the switch, then a specific macro is request from a TFTP server and applied to the interface.
 
shell trigger AP AP
macro auto execute AP remote tftp://x.x.x.x/ap.txt
 
This works great.

But for the event that the port changes to down, the switch does not respond with the corresponding trigger. I'm now looking my mistake.
 
I'm very grateful for a tip.

The macro I have attached in the appendix, I tried it with two times IF and IF ELSE. Unfortunately, neither brought any success

 

Kind regards

Kai

0 REPLIES 0
Create
Recognize Your Peers
Content for Community-Ad

ISE Webinars


Miss a previous ISE webinar?
Never miss one again!

CiscoISE on YouTube