Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,does any one know if fabric extender are compatible to a cisco catalyst 9500-40 X ?and what are the commands for it ?Currently we are running on: C6880-X-LE-DFC with two chassis virtual linked plus modules and 4 fabric extender also with mod...
Good Morning,
I encountered the following problem with my ISE 2.3 installation regarding Device Administration. When ich configure the primary or secondary node for AAA everything works fine, Tacacs Auth, aso. When I replace the primary and/or seco...
Dear sirs,
I have successfully configured network access on the ISE 2.3. On a successful authentication, a trigger is sent to the switch, then a specific macro is request from a TFTP server and applied to the interface.
shell trigger AP APmacr...
Hello to all,
I've created severals endpoint groups, which are filled with MAC-Adressess. For example one group for printer, one for access points and so on.
I can remember that on ISE 2.0 I created MAB compound conditions for authorization like ...
Good Moring,
After I added successfully some User Identity Groups by using "Work Centers -> Device Administration", I added some Local Identities to those Groups. The Policy Elements have also been added.
When I now try to add "Device Admin Polic...
Hello Tasneemjan,
to your topics:
make sure you have the following setup correctly:
1. On devices you are point to PSN ip addresses and not the PANs.
When I use the PAN IP's it works
When I use the PSN IP's its not working
2. If you are...
Hello,
I don’t understand this anymore. I did just that several times in the last week and I had no success. This Morning I checked again and by a surprise, the groups are now available.
I don’t get it.
Many thanks
Kai
Thanks, for the tip. This was the solution on one side. The other point I forgot, was that on the left side, when you "build" a compound conditon, you can used previous save conditions and I was wondering, why I can't see here the conditions I've use...
