Network Access Control

Hello I see ports 80,443,8443,8905, 8910, 9002, 9090 are opened on ISE and would like to close these ports from the wireless network. Can someone please advise if this is possible and if there are any concerns closing these ports. Thank you Sarat

I have a problem deleting files from the disk of my ACS 5.6 System, running on appliance (SNS-3415). In former I created some directories for different repositories.In one of those there are many orphaned files (about 42GB) that I want to delete. Unf...

My ACS went down today and when I brought it back up, the last log collected happend right before the shutdown. Everything is working fine except for the Live Authentication log. All processes are running as well. Any ideas?

I have the below radius configuration set on my Cisco 2921 running 15.2(4)M6. I'm having issues with setting the enable password to also use the radius group. For example, If I add "aaa authentication enable default group RADIUS_GROUP enable" to the ...

We have an ACS 5.2 Server and Need to Import more than 2000 MAC adresses. Can I use a bulk Import for the MAC adresses?

Hi, I have been running ISE 2.0 and wireless users on Cisco wireless controller are being authenticated through RADIUS  setup on ISE which is integrated with Active Directory and users get authenticated with AD credentials. Now I also want to setup T...

Hello, I have setup my controller and ISE for dot1x over wireless. I know what should be done as a best practice in terms of certificates and trusted CA...etc. However it is not do-able to verify the right certificates are on all endpoints especiall...

Hi guys, I've looked everywhere but couldn't find a how-to doc for configuring this, or maybe it's not possible? Currently, our ASA (7.5) authenticate admin users using radius (Microsoft NPS). We're looking to secure logon method by using 2 factor a...

Hello, I need to know whether ISE can record when the appliance administration account is used to log in via the console cable? What could be the specific report? For e.g. user names, commands issued, log in log out (time stamp)? Thanks, Ganesh

Hi Cisco Support, We can't view commands on the report viewer that was issue on non-cisco device. Can you assists us on how or is it supported on non-cisco devices? Is there any documentation for this kind of setup? Hope for your fast response. Th...