Network Access Control

Cisco Access Control Server (ACS), Identity Services Engine (ISE), Zero Trust Workplace
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

Labels

Forum Posts

Hi Everyone, I have a Primary Cisco ACS, called CiscoACS1, version 5.4 patch 6 with an IP address of 1.1.1.1/24 and a Secondary ACS, called CiscoACS2, version 5.4 patch 6 with an IP address of 1.1.1.2/24.Connectivity between them is ok, same subnets....

Hi, Is it possible to successfully re-image two ACS Servers to v5.5 from v5.3 but also successfully restoring backups, licensing and local certificates from v5.3. The current Log Collector is set to the Primary. I've read alot of documentation which ...

Hello I have a VPN tunnel between an ASA5520 and a Cisco 891.I had the 891 configured with the following:aaa group server tacacs+ VTY ip tacacs source-interface Loopback0!aaa group server tacacs+ TACACS-ACS server 10.8.x.x server 10.16.y.x!aaa authen...

Hello,we´ve a Cluster with 3 ACS5.5 Patch 3. Yesterday i´ve configured a lot. This morning the replication-id of the secondary Members differs.Master: 16587 ;  Secondary 16502.This results in a lot of problems, when the first server for authenticatio...

hdussa by Level 1
  • 1645 Views
  • 5 replies
  • 0 Helpful votes

Hi I have an ACS5.4 which is used for Authentication on my network. I need to set up Accounting for the devices on my network to see the following: 1. Who logged into the device2.  What changes have been made. I have configured the switch for AAA and...

jacovr by Level 1
  • 513 Views
  • 3 replies
  • 0 Helpful votes

Hi All I installed ACS 5.3 on a virtual machine to integrate it with gns3 , I can ping ACS IP from a gns router and vice versa , but when I try to access the GUI interface with admin username/password ,  it prompts me with " Invalid username or passw...

I'm using TACACS and ssh to access my rotuer and switches. What I need to do to enable audit? I want to get a report where I can see who logged in and what changes they made.Thanks.

nawas by Level 4
  • 567 Views
  • 2 replies
  • 0 Helpful votes