Network Access Control

Hi there,I wonder if there is way to export the configuration of the portals in a structured file, hopefully XML.Does anyone now it?Thx, Gio

I am running ISE 3.2 patch 4 and I am getting flooded with these messages:Details :Misconfigured Supplicant Detected with EndpointID=D4:BE:D9:9A:24:7F from user=host/gamble.mycompany.comDescription :ISE has detected mis-configured supplicant on the n...

Hello team Please help with understanding to choose correct virtual VM machines for network with 20,000 active concurrent session. I think about image 3655 with 4 nodes: PAN+MNT X 2 PSN X 2 what do you think? thanks in advance. regards Michael  

We upgrade the ise box from 2.4 to 2.7 version, and we found one error like "secondary admin node is added to the deployment, please register smart licensing" We tried update, but it didnt fixed. As a lat step we have de-registered the smart license ...

Hi ,We apply same config to another switch  and it is working.Its gives me below error. Kindly let me know what the error is it is.SW-9200-KP-OOB-UCS(config)# aaa accounting default group PCCU-ISEError: AAA authorization failed AAA_AUTHOR_STATUS_METH...

Hi Team,Below are the observations crossed while testing the backupScenario1:Whenever Primary nodes get reboot/failover/Switchover[Promote primary to secondary and Vice versa Secondary node will mark to Primary]  - Observed that automatic backup is g...

Hi Team,Observed the below error at some point, but not able to reproducible. 

Hello, I am going to integrate our cisco switches device admin access (TACACS) with Cisco ISE and DUO cloud with the user account located in our on-premises AD. The proposed flow was as follows Switch --> ISE ---> DUO Auth Proxy -->DUO Cloud The plan...

I'm running 3.1.0.518 P8 . I recently registered nodes in a distributed deployment. GUI was working fine, today someone reported that they couldn't get to the GUI. I tried from Chrome, Edge and Firefox no luck. The only change was them being register...

Hi,I'm working on an ISE-implementation and use ISE results for pushing interface templates to the switchports. This to keep the switch/interface configuration at minimum and only have configuration what is needed for the specific devices that will b...

Hi Guys, I'm installing ISE 1.2 on the network and when testing with few machines, some of them reported "errdisable" status on the port after applying the .1X configuration. The config for the port I have is:switchport access vlan 10switchport mode ...

Hello,As part of a project, I need to implement 802.1X within my company. Therefore, I have set up a physical lab consisting of 2 switches and two PCs:- Two Cisco Catalyst 2960 Series switches with Cisco IOS® Software, Release 15.0(2)SE5- PC with Mic...