I have a Cisco 3640 with 6 BRI's connected with a Cisco Secure ACS 2.3 using the TACACS+ protocol.
The Cisco 3640 is running c3640-i-mz_120-7_T and every call (vtemplate, vprofile, large scale dial-out) is working fine (including Calling Line IDentification CLID).
Due to new functionality (& bugs) I have to upgrade the 3640 image. I used version: c3640-i-mz_122-12a_T after installation everything was working except the ACS REFUSES CALLS for users which have Calling Line Identification active. (With the old image it did work.) Hardware and users aren't changed, I coudn't find the problem and have reactivated the old image.
My questions: Is this a bug?, Is there a new command in the 3640 to configure this ? How can I check that the 3640 sents the calling number to the ACS, which (tacacs?) debug command?
