We have 3 locations (B, T & R)The 3 locations will be interconnected with 3 E1 unframed lines. (visual: we have a triangle, corners are the locations, interconnected by the E1's)The hardware I use is 3x:Cisco 2621 with 1x VWIC-2MFT-G703Because the E...

I've a branch DMVPN network with 70 spoke routers and 2 hub routers. To create redundancy the hub routers are installed at different locations: if one hub router fails, eigrp & bgp routes the traffic via the other hub router.The DMVPN is based on DS...

I've a DMVPN up and running but if a node gets an other IP-address of the ISP or a router (node or hub) reloads it takes 2 - 3 hours before a new connection is established.I believe it's a timer problem (especially IPsec) But there are a lot of time...

I'm using DMVPN (1 mGRE Tunnel interface.)EIGRP runs on top of DMVPN with all nodes. Is it possible to specify/configure (on the HUB) which routes to advertise to a certain node (based on the nodes IP-address)? I've tried whith the "distribute-list...

Router "rpsaccess06" receives a route 192.168.99.16/28 via BGP and has to redistribute it into OSPF 1 (I use only area 0). A show ip route says that it redistributes it into OSPF but another OSPF router "rps-X25-TH01" doesn't have this route in it's...