Cannot disable DHCP on ACS

[lhf1]

I cannot disable DHCP on a Cisco Secure ACS. I am consoled into the device and run "set ip", choose "yes" for static IP and enter my IP information. However, after save, network test, etc... DHCP is still enabled and grabs an address on reboot. Anyone seen this or have ideas???

[m.sir]

I guess you are using ACS for Linux

you need to edit the INTERFACES section of /etc/rc.conf

DHCP='no'

IPADDR='x.x.x.x'

m.

[paulhowlett_2]

Hi, I had a similar problem on the Appliance (Ver 4.00). After the initial configuration I had to reboot and then re-enter both the IP and hostname. You also have to make sure that when you set up initially that the device is connected to the network. The re-entering the IP address was a TAC recommendation. Hope this helps.