Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, is it possible to use IPM to collect IP SLA data from devices that already have IP SLA policies on them? I can see how to add new IP SLAs from within IPM and then deploy them but I want to be able to use the existing IP SLA config on the route...
Hi, I am trying to get RME to email me when a change is made on one of our devices. Currently the email is generated only when a change is made through CiscoWorks (NetConfig etc) and not when a change is made directly on the device from an SSH sessio...
Hi, I'm using Switch PortReport Reclaim Unused Up reports, this seems to be working on some devices but not others (no pattern to the types of devices that are failing.) even though I know that device has ports that are administratively up but have...
Hi, is it possible to display port information on the Topology View maps? I'm exporting the maps into Visio. The hostname shows up but not port connectivity.Thank you in advance.
Hi, is it possible to to prevent CWLMS from polling certain IP addresses on devices that are in the inventory? For example only poll the management interface but not specific VLAN interfaces?Thank you in advance.
Hi, resurrecting an old post but I'm getting exactly the same error. The device I'm trying to import is listed under IPM devices in the 'Responder Enabled Devices', I've also tried adding it as an Adhoc target as it is both a collector and responder....
Hi thanks for your reply. What I'm expecting is to see any config change to be displayed in the Change Audit reporting. According to the documentation this relies on RME acting on a syslog generated by a device when a change has been made on that dev...
Hi, thank you for the reply. I've changed the history settingto 90 days and forced a major aquisition-still only get info for 10days. Getting the original error if I try and go beyond this. I know the ports haven't been used as I can run an SNMP quer...
Hi, thanks for your reply. I have been able to run reports on these devices before covering periods in excess of 30 days but only seem to be able to query a max of 10 days even though I know there are ports thathave not been used for over three month...
