Hi,
I have configured RADIUS authentication for VTY access to a Catalyst 2960S running 15.0(2)SE2.
The RADIUS server is a Microsoft server running the Network Policy and Access Service role (Microsoft's own RADIUS server).
Everything is ok apart from the login prompts. I want to customise these with a banner, username prompt and password prompt. I have added the lines below to my config:
aaa authentication banner ^Chello^C
aaa authentication password-prompt "Enter your password:"
aaa authentication username-prompt "Enter your username:"
However when I ssh to the switch I just see the output below:
login as: james.hawkins
Using keyboard-interactive authentication.
Password:
ASWTRE-BF01#
My config is shown below:
!
aaa authentication banner ^Chello^C
aaa authentication password-prompt "Enter your password:"
aaa authentication username-prompt "Enter your username:"
aaa authentication login default local-case
aaa authentication login SSH group radius local-case
aaa authentication enable default enable
aaa authorization exec default local
aaa authorization exec SSH group radius local
!
radius server TREREC-01
address ipv4 10.3.32.51 auth-port 1812 acct-port 1813
key 7 08171E61K281D08461C
!
!
!
line con 0
logging synchronous
line vty 0 4
exec-timeout 360 0
authorization exec SSH
logging synchronous
login authentication SSH
transport input ssh
line vty 5 15
exec-timeout 360 0
authorization exec SSH
logging synchronous
login authentication SSH
transport input ssh
!
Is there anything that I am missing?
