Currently, we deployed ISE 2.20.470 with Patch 4 in our environment. We are concerned about change the internal user password. Well in ACS 4.x. User change password by telnet/ssh on Router. Enter the username, enter the blank password. Router show prompt for enter Old password, then enter new password and lastly, Confirm New password. After that, user password has been changed and also shown in ACS Report . But in ISE, when we do same thing, it did not show in report. Only the password change via GUI can seen in report. I think due to this password counter has never reset for the user.
My question is
1. Is the same method did not applicable in ISE?
2. If not, then any other method.
