01-17-2017 11:54 PM - edited 03-11-2019 12:22 AM
Hi Guys,
Good Day!
I have an ISE installed in VM. I tried to change the IP address and it seems to be stock right after the stopping of services. Do you know why?
Thanks.
01-18-2017 04:44 AM
Is there any error message you are getting? Please post
Procedure to Change IP Address
You have to login to the console, using ssh. Then you'll have a CLI to change the IP address or assign IP addresses to other interfaces. The ISE user guide section has a document describing the commands. Note: after changing the IP address the ISE application is restarted automatically.
03-10-2017 10:30 AM
I have the same issue when we say "Y" to automatically cycle the services the CLI hangs and never returns. We left it for hours and we cant get the CLI back.
There is no other way even if we assign a new IP to a different NIC the services want to automatically restart and hangs.
No error no logging nothing
Did you get your issue resolved?
03-16-2017 11:34 AM
Ok so when the CLI 'hangs' or is 'stuck' at the very end of the process you can use CONTROL-C to 'kill' / terminate the session. This will get you back to the CLI from there you can then write mem and reload the box / application start ISE
Worked for me
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide