Cisco ISE 1.3 Patch 7 installation is stuck

[smcipnetz]

Hello,

I just started the installation of Patch 7 on our ISE 1.3 Patch5 distributed deployment. The Patch install seems to be working for over an hour now on our PAN. The last patches I installed were all set and done within 15-30 minutes per node so at the moment I´m a bit worried, that the installation is stuck. Did anyone of you experience such long install procedures? All the other nodes are running just fine, so I´m not too worried about the deployment in general.

Thanks in advance.

[daljitsin83]

Hi,

Any suggestion on this,  same issue.

Patch7 successfully installed on primary but for second node its running for hours.

We had to manually stop the installation, tried again but still no luck 

[daljitsin83]

Since no error found in debug install .We fixed it-

deregister from deployment- Upgrade standalone and then register back.

works.