
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2018 07:10 AM - edited 10-12-2018 07:11 AM
Hello all,
i've read through this document
but did not state
I have cisco ISE 2.3 distributed deployment 4 nodes, and I planning to update the patch, right now the condition is my ISE wasn't patch before, still the base version of Cisco ISE 2.3.
can I jump directly install into the patch 5 without install the 1 - 4 patches? and what happen if I just install the patch into some of the ISE nodes 2 nodes first and the other 2 nodes still using the base version in the distributed deployment?
there some document or link or answer for this case?
Thank you all
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2018 07:21 AM
Cisco ISE Software Patches
Cisco ISE software patches are usually cumulative. Cisco ISE allows you to perform patch installation and rollback from CLI or GUI.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2018 08:04 AM
ISE CLI command for reference
patch install ise-patchbundle-2.3.0.298-Patch5-18082702.SPA.x86_64.tar.gz <repository-name-that-holds-patch file>

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2018 07:21 AM
Cisco ISE Software Patches
Cisco ISE software patches are usually cumulative. Cisco ISE allows you to perform patch installation and rollback from CLI or GUI.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2018 08:04 AM
ISE CLI command for reference
patch install ise-patchbundle-2.3.0.298-Patch5-18082702.SPA.x86_64.tar.gz <repository-name-that-holds-patch file>
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2018 08:28 AM
so I can directly jump install to the latest patch (patch 5) without install the patch version (1-4) before? And it is okay to install the patch for only two nodes first and the other 2 nodes still in base version? it wouldn't take effect to the ISE if they have different version?
thank you
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2018 09:19 AM
