Cisco ISE 3.0 patch-3 is extremely SLOW

[adamscottmaster2013]

When I attempt to run a report for the past 24 hours, it takes a long time just scrolling through the page thus making it pretty useless.  Is this expected?

[Marcelo Morais]

Hi @adamscottmaster2013 ,

 please check:

 1st at Home > the Alarms dashlet for Slow Replication Error

 2nd at Administration > System > Deployment, check the Node Status of the Primary MnT

Hope this helps !!!

[adamscottmaster2013]

@Marcelo Morais:

Everything is Green and healthy with no replication error. 

[Marcelo Morais]

Hi @adamscottmaster2013 ,

 scrolling should be fast ... if the Alarm for Slow Replication and the Node Status are OK, then try to use another browser just to double check if it is not a browser issue.

Hope this helps !!!

[adamscottmaster2013]

@Marcelo Morais:  If it should be fast, I wouldn't be posting the question in the first place, LOL....

I tried from different browsers and different computers, same issue.

[Marcelo Morais]

Hi @adamscottmaster2013 ,

 when you said "... If it should be fast, I wouldn't be posting the question in the first place..." ... I'm sorry if I didn't make myself clear.

 When I said "...scrolling should be fast...", I'm just answering your 1st question: "... it takes a long time just scrolling through the page thus making it pretty useless.  Is this expected? ...".

 In other words ... I had problems before with a slow scrolling caused by Node Status with Slow Replication and also with a Browser issues ... but as you mentioned, it's not your case.

Regards.