Cisco ISE configuration with Avaya Switch

[deepakramanath]

Hi All,

I am trying to configure Cisco ISE, version 2.3 for a network device, Avaya switch. So far, I have managed to install the ISE 2.3 on a VM host and carry out initial setup via the CLI. The ISE admin portal is accessible via the web.

The idea is to make Cisco ISE with TACACS+ for AAA and configure a netwrok device (avaya switch) talk to the ISE for AAA. I am reading through the ISE administrative guide to carry out the configuration, however, given its exhaustive content, I' having difficulty to carry out the same.

Are there any tutorials on how to configure ISE that I can read/watch and learn from it? Or if I can get any assistance in configuring, it would be much appreciated.

[ognyan.totev]

Search Cisco Identity Services Engine Network Component Compatibility, Release 2.3 - Cisco

Is your switch supported.

[Jason Kunst · Accepted solution]

If avaya support device admin then it should work

Does ISE Support My Network Access Device?

i did a quick google search but don't see any specific docs on ISE and avaya, have you looked at the avaya documentation on how to configure?

[ognyan.totev]

Here is the Avaya and the version supported