09-14-2012 07:34 AM - edited 03-10-2019 07:33 PM
vmware 4.1 (or maybe 4.0.1)
configured with 2 core minimum freq 3.6Ghz
200Gb HD on single physical drive (minimum requirement),
no thin provisioning
datastore vmfs 3, 2Mb block size,
ethernet : flexible network adapter
ram 4Gb
Scsi controller
setup......
bum
.....
....
ISE Database listener not ready yet. Seconds left before timeout: 0
error:[cpminitialsetup.sh]
##########################################################################
ERROR: FAILED TO START DB!
Database is not available within timeout of 240 seconds.
This could be the result of incorrect network interface configuration,
or lack of resources on the appliance or VM. Please fix the issue and
run the following CLI to re-prime database:
'application reset-config ise'
error:[cpminitialsetup.sh]
##########################################################################
Any advice?
03-21-2013 06:33 PM
Please make sure that the ISE has access to ntp and dns (both forward and reverse records).
and as you are using VM machine so 60 to 600 GB of disk storage (size depends on deployment and tasks) are required. But 200 GB or more disk space are required to a production environment.
In your case, I highly recomand you to allot a minimum of 200 GB of disk space and use a hard disk drive with a minimum of 10,000 RPM.
ISE must be installed on a single disk in VMware. If you use several small disks to meet the disk space requirement for installing ISE, you might experience some unexpected behavior.
01-23-2014 06:00 AM
I've got same problem. ISO image was broken. Check MD5.
09-06-2014 05:07 AM
Hi
I faced this issue today;
It was due to NTP misconfiguration; the server was not syncrounised with NTP server
When I fixed the NTP issue the server working fine I just run
application reset-config ise
the server now is up
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide