Cisco ISE pxGrid Service Not Starting

[SG_GS]

Hello,

My team is currently getting ready to install DNA Center, and so I have been getting our ISE environment ready to integrate with it. I saw in the requirements that we need to enable pxGrid, but after enabling it I'm not seeing the service started when I check the CLI using "show application status ISE".

Will the pxGrid services only start once you have clients attempting to connect? The videos I've seen show the service being started immediately, and I want to make sure that we have everything ready when we begin the process of setting up DNA Center.

For reference, we are on ISE 3.1, have two nodes in our deployment, and I'm following this guide: How To Cisco DNA Center ISE Integration - Cisco Community

[davidgfriedman]

I don't know if this helps, but I just enabled it for lab node via the gui. I came back a week later and created a certificate for sign-up, then use the postman collection to request an ID/PW (which I approved since it was me).  I didn't check on any services, not need any other checkboxes for that to work.  Earlier this week I also tested with our SOC, who we did a new CSR and was able to connect up with that pcks (12 was it?) and then request an ID (which I also approved).  So that's two successes with just one GUI checkbox click so far, though we have not made time for the subscription testing yet.   I hope that helps.

[ahollifield]

ISE 3.1 is pxGrid 2.0 only.  IIRC the service does not show the same way it did on previous versions as that service referenced pxGrid 1.0.

[sun.siqi]

Hi did you slove this problem?

I also see the same problem, and wondering how to slove it LoL