cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

806
Views
0
Helpful
2
Replies
Andrew Chapman
Beginner

Cisco ISE restore from VM snapshot

Hello,


We have a distributed ISE deployment (1.3.0.876) in which a patch install failed and rendered our PAN unreachable. We have promoted our secondary to be the new primary and would like to restore the snapshot on the "old" PAN. My question is how exactly does the snapshot restore affect the state of the admin nodes? Since our secondary is the current primary, does it retain its role even after the old restores?


Thanks,


Andrew

1 ACCEPTED SOLUTION

Accepted Solutions

Hi,

 

It will retain its old settings. You can after you have reverted the snapshot reboot the device. It will pickup there is already a primary node active and assume the standby roll.

 

Regards,

Jason

View solution in original post

2 REPLIES 2
franklinb
Beginner

Why not bring the VM up offline and set the role to Secondary before reconnecting?

Hi,

 

It will retain its old settings. You can after you have reverted the snapshot reboot the device. It will pickup there is already a primary node active and assume the standby roll.

 

Regards,

Jason

View solution in original post

Content for Community-Ad