Cisco ISE - TACACS logging for IPv6 network devices

[Sven Hruza]

Hello,

I configured now IPv6 network devices and we successfully authenticated with TACACS.
But my TACACS log and the reports are empty.
The internal logging is configured with the IPv4 addresses of the ISE appliances. And IPv4 device authentications are visible.

ISE version is 3.3 with patch 4.

Is there anything I need to configure to make the IPv6 authentications visible in the live log and reports?

Thanks in advance!
Sven

[Marcelo Morais]

Hi @Sven Hruza ,

 in Operations > Reports > Reports > Device Administration > ALL the Reports (Authentication Summary, TACACS Accounting, TACACS Authentication, ...) are empty, is my understanding correct ?

Regards

[Sven Hruza · Accepted solution]

Yes it was empty. A service restart on the appliances doing the primary logging service helped.
Now all looks fine and same for IPv4 and IPv6.
No idea what happened here....

Thanks anyway!

[Marcelo Morais]

Hi @Sven Hruza ,

 excellent news !!!

Regards