cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

217
Views
0
Helpful
1
Replies
aslam.bajwa
Participant

Cisco ISE2.4 Patch 9 , End User not getting IP address.

Hi All ,

 

I am facing some strange issue , some of my end-point are authenticated successfully , showing complaints also  but not getting IP Address .

 

Please advise .

 

 

Regards ,

1 ACCEPTED SOLUTION

Accepted Solutions
Surendra
Cisco Employee

Are you changing any VLANs after the posture status changes to complaint ?

Change the following settings in the Posture profile on the ISE and see if it helps :

Ping or ARP attribute to the Value “Ping then ARP” instead of “Ping” to detect the network change.
Change the Ping timeout to 5 seconds.
Change the DHCP release delay to 2 seconds.

View solution in original post

1 REPLY 1
Surendra
Cisco Employee

Are you changing any VLANs after the posture status changes to complaint ?

Change the following settings in the Posture profile on the ISE and see if it helps :

Ping or ARP attribute to the Value “Ping then ARP” instead of “Ping” to detect the network change.
Change the Ping timeout to 5 seconds.
Change the DHCP release delay to 2 seconds.

View solution in original post

Content for Community-Ad