Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1758
Views
0
Helpful
1
Replies

CiscoSecure ACS does not display dialout users

mgeoghegan
Level 1
Level 1

‎07-09-2002 08:43 AM - edited ‎02-21-2020 10:02 AM

We are using "Dialout/EZ" to allow users to dialout through our AS5300. Users can dial out and when you do a "sh users" on the NAS the username is displayed. When I go into our CiscoSecure ACS, and go to "Logged in users" they are not displayed. TACACS+ account does not display anything either. They are authenticating through the ACS not a local account on the NAS.

Labels:
0 Helpful
1 Reply 1

yusuff
Cisco Employee
Cisco Employee

‎07-10-2002 04:11 AM

You need accounting enabled for "Logged in users" to show up. Also the NAS must perform authentication and accounting using the same protocol—either TACACS+ or RADIUS

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacs4nt/csnt30/user/r.htm#xtocid1932813

HTH

R/Yusuf

0 Helpful
Customers Also Viewed These Support Documents