Network Access Control

Hi,With CAR, I need to assign different IP pool for request coming from different NAS. Can anyone tell me how to do it or where can I find related document? Thanks a lot.NAS1-------- (IP pool 1:10.1.0.0/16 for NAS1)NAS2--------Radius Proxy--------CAR...

I have a very specific IOS Version 12.1(8a)E4 ! It is very difficult to find documentation on that specific version.How do you find your way in all that doc.I just had to find how to configure ACS on that routeur and It took me a week and most of my ...

We are using ACS for WIN2000 ver 3.1 and we are trying to configure external database authentication using a generic LDAP database on an AIX ver 5.2 running LDAP ver 3. The AAA client is a regular router using TACACS protocol, and we are trying to te...

Can the PIX pass authentication 'Outbound' to a RADIUS Server?I know it works 'Inbound' but what about Internal users getting Authenticated and Windows Rules set for Outbound access??Thanks,Bob

Hi,I have an inside network behind a pix-515 firewall. I want to enable aaa for the internet traffic in a manner that when a user on the inside zone tries to access Internet a window pops up asking for username and password . Upon entering the userna...

Hi,we are using tacacs while normal operation but we want to be able to have two console passwords for troubleshooting if connectivity is lost In many cases we are not onsite in case of an error and in such a situation we want to give a temporary acc...

Users can call to my 3640 and, after it authenticates them with AAA RADIUS, it makes a callback and it works fine. I need to authenticate the users with RADIUS and SecureID. The initial authentication works fine, but when the router calls back the ko...

Running PIX ver 6.2(2) with DES activation key 56 bit.Trying to get VPN3000 client ver 3.6.3 to vpn through the PIX. Can this be done using local usernames configured on the PIX itself ? Or do you have to use an external Radius server ?

I want to configure a time based network access restrictions to Cisco router.Is it possible to restrict a telnet access for user X to Cisco router only to 1:00PM-4:00PM using RADIUS AAA ?I have a Steel-Belted RADIUS server from Funk Software.

after I configured the ACS 2.6 on a windows 2000 server I am not able to start the radius service returning error 11 as reported by windows all other related Cisco Secure services star exept radius.Please comment.Regards,Kassa

I am seeing Radius records with Acct-Status-Type "NAS port reused". I have never seen this before. The NAS in question is a 3660 running 12(2)8T. I would appreciate any info on the meaning of this record type.TIAMike

Has someone tested aaa control in a PIX for traffic coming from the remote lan over a site-to-site vpn from a remote peer ? Thanks in advanceRenato

Has someone tested aaa control in a PIX for traffic coming from the remote lan over a site-to-site vpn from a remote peer ? Thanks in advanceRenato

Please if somebody knows this product part number please send it to me. I need to quote it.

Can ACS 3.1, VMS 2.1 and CiscoWorks for Windows 6.1 play nicely with each other if loaded onto the same server? Please take into account a small (>100 users) network that will probably not grow to over 75 users in the next few years. Thanks in advanc...