We are set up to where we have computers on vlan 11 and phones on vlan 12, and they are daisy chained such that the connection from the wall goes through the phone first, ten into the PC. We are finding that for some reason, on Catalyst 3650 switches, we can put a config n the switchport of auth host-mode multi-domain, and this causes ISE to profile both the phone and the PC on the respective port. However, on our Catalyst 2960X switches, if we try this command, then it profiles only the phone and not the computer and blocks the PC from connecting. I also tried auth host-mode multi-host and auth host-mode multi-auth and they did not achieve the desired result either. Does the Catalyst 2960X series switches simply not allow two devices on two different vlans to profile on the same port?