critical vlan in low impact mode

[ipagliani]

Hello,

How is it possible managed a server radius failure when I'm using low impact mode and a port acl is applied ?

Is there a similar configuration like critical vlan used in high security mode ?

Regards,

Iarno

Sent from Cisco Technical Support iPad App

[Tarik Admani]

Larno,

If you are still in low impact mode then you can leave the critical vlan as the same vlan as the access vlan then verify how the user was authorization by issuing a "show authentication sessions" command if you are going to place the users in a guest vlan or a vlan that has limited access then the port acl will only apply to the ingress traffic from the port not from any ACLs that exist on the L3 interface itself.

Thanks

Tarik Admani