10-30-2024 11:11 AM
I managed to set up two ISE servers with the help of YouTube. They are fully configured in HA mode, but for some reason, the default Authentication Policy is not displaying, and there is no option to create my own policy under the settings. Does something need to be enabled at the hardware level for the policy to display? Any suggestions?
10-30-2024 01:24 PM
Might be a browser issue? By default the Policy Sets should always be visible without needing any tricks.
Try a different browser, clear cache etc.
What version of ISE? You should always patch after a base install too. Some .0 releases have been known to be a bit "fresh out the oven" ... but I have to admit I have never seen this issue.
10-30-2024 01:47 PM
Yeah I agree a browser issue. Or this is an ancient version of ISE that still utilizes flash. But IIRC this specific page does not use the flash elements.
10-30-2024 02:11 PM
Hi,
Try a reload and a different browser, use Chrome.
Best,
Cristian.
10-31-2024 07:33 AM
The screenshot you shared shows TACACS+ policies, is that what you are looking to configure or are you looking to configure RADIUS policies? To enable TACACS+ you would need to go to Administration > System > Deployment > Click on each node > Enable the tick box called "Enable Device Admin Service". For RADIUS however, you need to enable the tick box next to "Policy Service" option.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide