
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2018 11:08 AM
Hi
I would like to confirm if "Deploy" button on ISE's IP-SGT binding page is pressed, will it configure the switches with "cts role-based sgt-map 1.1.1.1 sgt 10" commands?
My customer have a SDA setup with DNAC (version 1.1.6) integrated with ISE (version 2.3 patch 2).
When I configure IP-SGT bindings in DNAC, it is pushed to ISE properly. When I click on "Deploy" button, I see "cts role-based sgt-map..." commands on the switches. These configurations are not made by DNAC, which we have confirmed. These are made ONLY when we click on "Deploy" button.
Please confirm if this is expected.
Thanks and Regards
V Vinodh.
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2018 11:51 AM
It is confirmed that ISE configures IP-SGT bindings when clicked on Deploy button.
Thanks and Regards
V Vinodh.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2018 11:51 AM
It is confirmed that ISE configures IP-SGT bindings when clicked on Deploy button.
Thanks and Regards
V Vinodh.
