Help getting user created in ACS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-21-2014 07:22 AM - edited 03-10-2019 09:18 PM
I'm a new employee and have been added to AD. I can login to my workstation and everything OK but I'm not showing up in the ACS DB. I have all the same group and user memberships and rights as my fellow network engineers but for some reason I don't show up. It's been about a week so everything should have syncen in AD.
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-21-2014 07:35 AM
Could you grant us more information, in terms of ACS version and what type of authentication this may be.
**Share your knowledge. It’s a way to achieve immortality.
--Dalai Lama**
Please Rate if helpful.
Regards
Ed
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-21-2014 10:31 AM
It's version 4.2 and it's in getting the user to show up in the ACS DB. I haven't even gotten to the part where I try to login into anything as I'm not showing up in the DB yet.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-21-2014 04:19 PM
Hi Tony,
If you are already there on ACS-AD, you will show up as a dynamic user in the ACS DB only when you perform the first successful authentication.
**Share your knowledge. It’s a way to achieve immortality.
--Dalai Lama**
Please Rate if helpful.
Regards
Ed
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-22-2014 05:22 AM
I have successfully logged in to the wireless network but don't show up in the ACS DB. I tried logging into a switch but authorization failed due to my not being in the ACS DB and not being in the proper group for switch authorization in ACS.
