HELP NEEDED on DIAL-in with ACS(Tacacs+)

[j.hato]

Hi gurus,

Please help:

acs (net

172.16.1.12)---PIX(10.0.20.1/28)-----(10.0.20.32/28)PIX----NAS

Router (Fa0/0 192.168.0.1)--Dial-in User.

NOTE:

--Between PIX there has 2 network coz go through

service provider

--The Fa0/0 has being NAT-ed to 10.0.20.46.

--I can ping from NAS Router to ACS server

--The ACS has being NAT-ed to 10.0.20.20

--The Dial-in user on succeed dialed would be given to

IP network 192.168.0.xxx then NAT-ed to 10.0.20.xxx

(but the dial having a problem which is shown at the

attachment)

-- I have point the NAT-ed ACS server at the NAS

Router as TACAC+ server host

I couldn't found any help on cisco.com the error msg

wasn't at the cisco "error msg tool"

Thank u

HATO

[sirpa_k]

What was the exact error message? any update on this ?

[j.hato]

Hi Sirpa,

thank you for your response. But the problems had been counteract. The error was came from the router when I check the PIX ohhhh the PIX at both side block the traffic.

HATO