cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2602
Views
0
Helpful
4
Replies

How to apply multiple Frame-Route via Cisco ISE

cheery Tomato
Level 1
Level 1

How to apply multiple Frame-Route via Cisco ISE

 

I have devices authenticating and getting an IP address applied via Cisco ISE.

Now I want to advertise routes from the the authenticated devices via Cisco ISE using the RADIUS attribute 22 (RADIUS:Framed-Route).

I currently can apply an individual Framed-Route successfully but need to advertise multiple routes fromt he devices, is this possible.

 

Any help is greatly appreciated.

Cheers.

 

 

 

1 Accepted Solution

Accepted Solutions

cheery Tomato
Level 1
Level 1

I applied a single address to the end point and using that address did a NAT overload on the address to connect into the network.

Later when this was working for a while I created GRE tunnels to the addresses and advertised the network routes through these tunnels.

View solution in original post

4 Replies 4

cheery Tomato
Level 1
Level 1

I applied a single address to the end point and using that address did a NAT overload on the address to connect into the network.

Later when this was working for a while I created GRE tunnels to the addresses and advertised the network routes through these tunnels.

sanjayk9
Cisco Employee
Cisco Employee

Hi

cisco_sec_geek
Level 1
Level 1

Hello,

I'm about to implement the same policy for LTE platform.

Could you please share the policy for Authentication and Authorization.

Thank you

I’d recommend a new thread referencing this one